Kodak i260 Scanner Firmware v2.5.5

Kodak i260 Scanner Firmware description

Operating System:Firmware , 1.43 Mb
Kodak i250/i260/i280 Scanner Firmware v2.5.5.

Installation Instructions:

Click on i200 Firmware and download the file to a temporary directory on your C drive.

Double click on the file to extract the firmware files. By default the files are placed in the C:/Temp directory. Or, you can enter the directory of your choice. For ease of installation we recommend using C:WINNT wain_32kodakkds_i200Firmware.

Click on the Unzip button to extract the files. You can now delete the i200FW_vxxxxx.exe file to save space on your PC.

Next, use the Scan Validation Tool to download the i200_xxxxxx.ekpgfw file from the directory selected in the previous step. You will find the Download button under the Setup tab of the SVT.

After the download has completed, power the scanner off, and then back on.

To activate the new features of the scanner you MUST perform a scanner calibration. We strongly recommend you do Kodak i260 Scanner Firmware v2.5.5 immediately after installing the firmware and rebooting.

IMPORTANT Note for KODAK Capture Software Users: If you install the latest SVT 5.24 and Firmware 2.5.5 you must use KODAK Capture Software Version 6.6 or higher in order for the scanner to work properly. Download the Lite version of Capture Software. To upgrade to the latest Full version of Capture Software, contact your Regional (local) Kodak Support Center.

Kodak i260 Scanner Firmware Install

1. Download Kodak i260 Scanner Firmware v2.5.5 and save it to PC hard disk.
2. Run Kodak i260 Scanner Firmware v2.5.5 and it will install automatic.
3. Reboot your computer to finish your Kodak i260 Scanner Firmware installation.

Kodak Scanner Driver Related Drivers