NETGEAR KWGR614 Wireless Router Firmware 1.0.0 09.25

NETGEAR KWGR614 Wireless Router Firmware 09.25 description

Operating System:Firmware , 1.76 Mb
NETGEAR KWGR614 Wireless Router Firmware 1.0.0_09.25.

New Features:

Added the “Dynamic L2TP” support (in additional to the Static L2TP) for some ISP broadband accesses.

Added the feature to avoid “LAN/WAN IP configuration conflict”: NETGEAR KWGR614 Wireless Router Firmware 1.0.0 09.25 version can detect and avoid the installation problem automatically when the WAN side uses the conflicting IP address configuration as the LAN side.

The 1st release of the NA (Northern American) firmware compliant with the FCC requirement: the wireless region is fixed to US, and only channel 1~channel 11 selection allowed. The wireless radio is ON by default. The default Time Zone is US.

Intel ViiV certifiable: implemented the hidden page (“router-info.htm”) for the access of the Intel ViiV management software.

The 1st release of the WW (worldwide) firmware for EU, AU, etc (except US)

SIP ALG supported for VoIP applications

Added the system recovery capability: In case the flash image is damaged (because of improper or interrupted upgrade process, or bad firmware image programmed by the open source developers, etc), NETGEAR KWGR614 Wireless Router Firmware 1.0.0 09.25 version allows re-loading the firmware via TFTP. The procedure is: 1.Power off the unit; 2.Press and hold the RESET button at the rear panel; 3.Power on to reboot the unit; 4.Monitor the Test LED, and keep holding the RESET button until the Test LED changes from blinking to steady ON (which means the boot loader has entered the TFTP recovery mode); 5.Connect the PC to the LAN port of the unit; 6.Transmit the firmware image file to the unit: For Windows PC, enter the DOS command: tftp -i 192.168.1.1 PUT KWGR614_XXX.bix, For a Linux PC, use the command: tftp -m binary 192.168.1.1 -c put KWGR614_XXX.bix, where the “192.168.1.1” is the unit’s LAN IP address and “KWGR614_XXX.bix” is the firmware image file to transmit; 7.Monitor the Test LED. When NETGEAR KWGR614 Wireless Router Firmware 1.0.0 09.25 starts blinking, the recovery procedure is complete; 8.Power cycle to reboot KWGR614, Repeat the above steps if the procedure is interrupted or failed.

Known Issues: Video and Audio of ICQ5 connection cannot be established.

Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.

NETGEAR KWGR614 Wireless Router Firmware 09.25 Install

1. Download NETGEAR KWGR614 Wireless Router Firmware 1.0.0 09.25 and save it to PC hard disk.
2. Run NETGEAR KWGR614 Wireless Router Firmware 09.25 1.0.0 and it will install automatic.
3. Reboot your computer to finish your NETGEAR KWGR614 Wireless Router Firmware 09.25 installation.

NETGEAR Network Driver Related Drivers